Damon Astoria 2006 Owner's Manual Page 61

  • Download
  • Add to my manuals
  • Print
  • Page
    / 112
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 60
Chapter 9 - Care and Maintenance
such as adding oil, changing lters, or replacing spark plugs, could be accomplished
at an auto service center, but must be done in accordance with the service instruc-
tions speci ed by the generator manufacturer. Refer to the Generator Owner’s
Manual for further information.
The LP gas system should be checked regularly for leaks and road damage. Fol-
low the lines, looking for kinks or attened spots that may have occurred during
travel or maintenance on the recreational vehicle. A quali ed LP gas service
technician using proper equipment should check the entire system annually or
whenever you suspect a problem.
The line pressure for LP gas appliances should be checked at least every six
months. Most LP gas suppliers have this equipment to do the test for you.
All service procedures should be performed only by a certi ed LP
gas service technician.
Some components of the recreational vehicle are constructed of strong, light-
weight ABS plastic. Sometimes, it may be necessary to remove stains, or generally
clean. A mild solution of soap and water will clean many stains, and should be used
initially. Tougher stains may require stronger cleaners, but be sure to read the label
to determine if the product is recommended for use on plastics. Avoid abrasive
cleansers (even the liquid and cream types), alcohol based products, and solvents
such as acetone and MEK. Gasoline and kerosene should not be used because of
the damaging effect they have on the plastic surface, as well as the re hazard
they present. Often the damage caused by solvents, alcohol, and oil based prod-
ucts may not be immediately noticeable, but the plastic is made weaker, and thus
more prone to stress cracking.
The front suspension and steering system of this vehicle was factory aligned using
highly accurate equipment prior to delivery to the dealership. However, we rec-
ommend that alignment be checked and if necessary, adjusted after you have fully
loaded the motorhome according to your personal needs. Thereafter, the align-
ment should be inspected annually to help prevent uneven tire wear. All align-
ments and incurred costs are the responsibility of the retail owner.
Check that the top and bottom bracket screws are tight at the start of each camping
season.
1. Lubricate the rafter arms and support arms using paraf n wax or silicone spray.
Also lubricate the threads on the knobs.
2. Periodically clean the awning fabric as follows: For a vinyl material use a mix-
ture of 1/4 cup of dish soap and 1/4 cup of bleach mixed with 5 gallons of warm
water. Liberally apply this mixture on the top of the fabric, then roll the awning up
for 5 minutes. This will apply the mixture to the bottom as well. Roll the awning
ABS PLASTIC PARTS
MOTORHOME
ALIGNMENT
AWNING
EXTERIOR
LP GAS SYSTEM
Page view 60
1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 111 112

Comments to this Manuals

No comments